I am using Marlin 2.0 on arduino due. (I have tried 3 different updates about 2 weeks apart each)
Marlin is not heating, moving motors for me.
Temperature sensing works and it talkes to pronterface.
I turned on PID echo and it says it is setting PWM to 255, but the FET and arduino pin are not outputing. I have uploaded a blink sketch using the same heater pin and it heats up fine.
The steppers also do not turn when I sen a move command. They do become realy difficult to turn, so they are getting powered.
Thanks and let me now if I need to post more info, this is starting to drive me crazy.
Marlin is not heating, moving motors for me.
Temperature sensing works and it talkes to pronterface.
I turned on PID echo and it says it is setting PWM to 255, but the FET and arduino pin are not outputing. I have uploaded a blink sketch using the same heater pin and it heats up fine.
The steppers also do not turn when I sen a move command. They do become realy difficult to turn, so they are getting powered.
Thanks and let me now if I need to post more info, this is starting to drive me crazy.