Ok I have been struggling with this for about 2 weeks now and I had to step away from it to stop my brain overheating.
So I have a geeetech I3 pro B printer that ran with out a problem until I used the new cura update which totally scrambled its movement.
I downloaded the new marlin and used the I3 pro B profile which compiled and loaded fine.
With the help of a forum user on here called dust I went through all the basics of the code and ensured the everything is as it should be. (Many thanks to him for his advice and patience)
Now comes the issues
The z axis will raise but wont home.
The x axis emits a loud buzzing and homes but the motor continues to pull as if the end stop is not there.
The y axis is demonstrates a similar problem.
The LCD panel shows the axis positions but continually flashes with a question mark even when homed.
My experience with code is limited so any advice would be great
So I have a geeetech I3 pro B printer that ran with out a problem until I used the new cura update which totally scrambled its movement.
I downloaded the new marlin and used the I3 pro B profile which compiled and loaded fine.
With the help of a forum user on here called dust I went through all the basics of the code and ensured the everything is as it should be. (Many thanks to him for his advice and patience)
Now comes the issues
The z axis will raise but wont home.
The x axis emits a loud buzzing and homes but the motor continues to pull as if the end stop is not there.
The y axis is demonstrates a similar problem.
The LCD panel shows the axis positions but continually flashes with a question mark even when homed.
My experience with code is limited so any advice would be great