Everything seems to be working fine exept for two things:
When I use Auto Homing the print bed only moves 10mm to the opposite direction of the end stop. That causes a lot of problems when starting or pausing prints. Printing itself is working pretty good actually but the homing doesnt work.
Things I have noticed/tried:
-used another cable
-made sure its wired correclty
-pushing the end stop while homing
-try to auto home with the Y end stop unplugged
-invert end stop in marlin (this caused the print bed to move towards the end stop but it never stopped moving)
-tried the end stop noise filter with lvl2 sensitivity in marlin
The second problem is that i suffer a lot from underextrusion I think during the first 20-40 layers. Initial layer and the layers after the first 20-40 are looking great btw.
When I use Auto Homing the print bed only moves 10mm to the opposite direction of the end stop. That causes a lot of problems when starting or pausing prints. Printing itself is working pretty good actually but the homing doesnt work.
Things I have noticed/tried:
-used another cable
-made sure its wired correclty
-pushing the end stop while homing
-try to auto home with the Y end stop unplugged
-invert end stop in marlin (this caused the print bed to move towards the end stop but it never stopped moving)
-tried the end stop noise filter with lvl2 sensitivity in marlin
The second problem is that i suffer a lot from underextrusion I think during the first 20-40 layers. Initial layer and the layers after the first 20-40 are looking great btw.