ABL does not seem to work properly. What should I do? (no replies)

ABL does not seem to work properly. What should I do?

1.Will not be effective?
#define RESTORE_LEVELING_AFTER_G28

2.Does M851 not work?
Nozzle height does not change even if [num] is changed
#define NOZZLE_TO_PROBE_OFFSET { 0, 18, [num1]}
M851 [num]


What I did.
download bugfix-2.0.X 11/02/2019
platformio home 2.3.3 core 4.0.3
python 3.8.0(64bit)
see config.zip


G28
G29
Bilinear Leveling Grid:
0 1 2
0 +4.107 +4.342 +4.567
1 +3.592 +4.047 +4.659
2 +3.417 +4.088 +4.995
X:224.00 Y:206.00 Z:5.06 E:0.00 Count X:35840 Y:65920 Z:64000
ok

M500
M501
M851 check Z-Probe Offset [num1]

POWER OFF/ON

M851 [num]
M500
M501
M851 check Z-Probe Offset OK

POWER OFF/ON

G28
M420 V
0 1 2
0 +4.107 +4.342 +4.567
1 +3.592 +4.047 +4.659
2 +3.417 +4.088 +4.995
echo:Bed Leveling OFF <-----is this correct?
echo:Fade Height OFF

M851 check Z-Probe Offset OK

M420 S1
M420 V check Bed Leveling ON

G90
G1 Z10
G1 X10 Y10 Z0
M420 V check Bed Leveling ON
M851 check Z-Probe Offset OK