Been a long road but my FLSUN kossel is almost ready to print again.
I have everything set using the manual configuration process to modify the Marlin script using Arduino.
However, now I have all the tower heights exactly the same the centre height is 0.7 mm above the bed at Z0.
I cannot find anything to guide me in this last adjustment that relates to the current Marlin version.
Everything I find refer to DELTA SMOOTH ROD OFFSET, but the new version does have this code at all.
I have not been able to find a work around, can anyone help?
I no longer have an effector with auto-calibration end-stop so I need to figure this out.
I have everything set using the manual configuration process to modify the Marlin script using Arduino.
However, now I have all the tower heights exactly the same the centre height is 0.7 mm above the bed at Z0.
I cannot find anything to guide me in this last adjustment that relates to the current Marlin version.
Everything I find refer to DELTA SMOOTH ROD OFFSET, but the new version does have this code at all.
I have not been able to find a work around, can anyone help?
I no longer have an effector with auto-calibration end-stop so I need to figure this out.