Hi,
I Upgraded my Anet A8 from Original to Ramps 1.6 with Marlin 1.8.10.
I can read the temperature from the hotend and the bed, and when i set the bed or hotend to heat up, there isn't even voltage on the connectors for them.
As a board i set BOARD_RAMPS_14_EFB.
Even the Fan which is connected to D9 doesn't start.
I tried Marlin 1.1.9, 1.1.x bugfix, 2.0,x bugfix and i even tried Repertier 1.0.4 (Motherboard 33) - its always the same: no voltage on D8,D9,D10
br
michael
I Upgraded my Anet A8 from Original to Ramps 1.6 with Marlin 1.8.10.
I can read the temperature from the hotend and the bed, and when i set the bed or hotend to heat up, there isn't even voltage on the connectors for them.
As a board i set BOARD_RAMPS_14_EFB.
Even the Fan which is connected to D9 doesn't start.
I tried Marlin 1.1.9, 1.1.x bugfix, 2.0,x bugfix and i even tried Repertier 1.0.4 (Motherboard 33) - its always the same: no voltage on D8,D9,D10
br
michael