Dear Brother And Friends
Good day to you, I have a Melzi 2.0 Board which is equipped with Atmega1284p, I downloaded marlin 2.0 firmware yesterday. because I wanted to add an inductive sensor for auto bed levelling, I am using VS CODE and PlatfromIO. however, everything seems to compile nicely but always have a problem at the end of the compilation. can anyone help me?
I have dug into the issue too before I do the steps, reference is the below two youtube videos
Video One - That It Can Be Done
Video Two - Trials With Firmware Where I Followed the Steps Exactly
I Have attached The Configuration.h File So You Can See Or Check What's Going Wrong.
The Picture Of The Board I Have
![s-l300.jpg]( "s-l300.jpg")
The Compilation Error I Am Getting
![2020-02-07-17h44-43.png]( "2020-02-07-17h44-43.png")
![2020-02-07-17h44-55.png]( "2020-02-07-17h44-55.png")
![2020-02-07-17h45-29.png]( "2020-02-07-17h45-29.png")
Good day to you, I have a Melzi 2.0 Board which is equipped with Atmega1284p, I downloaded marlin 2.0 firmware yesterday. because I wanted to add an inductive sensor for auto bed levelling, I am using VS CODE and PlatfromIO. however, everything seems to compile nicely but always have a problem at the end of the compilation. can anyone help me?
I have dug into the issue too before I do the steps, reference is the below two youtube videos
Video One - That It Can Be Done
Video Two - Trials With Firmware Where I Followed the Steps Exactly
I Have attached The Configuration.h File So You Can See Or Check What's Going Wrong.
The Picture Of The Board I Have
The Compilation Error I Am Getting
