Hello
I'm reparing a Delta Printer and I'm setting it up with a new Marlin 1.1.9 firmware.
I started from the delta basic configuration file. I've come so far to be able to print a small test dice cube. (It's far from perfet. But I'll get there. :-) )
I have the following questions according to the settings in marlin 1.1.9:
1. How can I set an offset for the nozzle?
My printhead supports two extruders. But only one is installed/used. But because of the design the extruder (therefore the nozzle) is not in the middle of the printhead. But because the plate with the printhead goes to X0 Y0 the print is deviated. (Is this clear?)
How can I adjust the origin in the X- and Y-axis accordingly in the firmware?
So for example I set an offset for X = 10 and Y = -10 and then the origin is moved accordingly.
Does this cut off some printing area when I set my radius to 120? Or does it move the whole printing area as well?
Many thx for any help.
theliadir
I'm reparing a Delta Printer and I'm setting it up with a new Marlin 1.1.9 firmware.
I started from the delta basic configuration file. I've come so far to be able to print a small test dice cube. (It's far from perfet. But I'll get there. :-) )
I have the following questions according to the settings in marlin 1.1.9:
1. How can I set an offset for the nozzle?
My printhead supports two extruders. But only one is installed/used. But because of the design the extruder (therefore the nozzle) is not in the middle of the printhead. But because the plate with the printhead goes to X0 Y0 the print is deviated. (Is this clear?)
How can I adjust the origin in the X- and Y-axis accordingly in the firmware?
So for example I set an offset for X = 10 and Y = -10 and then the origin is moved accordingly.
Does this cut off some printing area when I set my radius to 120? Or does it move the whole printing area as well?
Many thx for any help.
theliadir