Hello. I would like to ask experienced people. No one thought about the possibility of altering a pause and changing the filament in the Marlin firmware?
I have been using Anet A6 printer for 2 years and decided to change the firmware to Marlin 1.1.1
On the firmware that was installed on the printer board, pause and change of filament worked very well (when paused, the extruder simultaneously moved up and diagonally, moving away from the model, and then drove home along X and Y)
When pressed back, the extruder returned to the model and printed it further.
Now, actually, the question is: is it possible to make the same pause and change of filament on Marlin firmware?
I have been using Anet A6 printer for 2 years and decided to change the firmware to Marlin 1.1.1
On the firmware that was installed on the printer board, pause and change of filament worked very well (when paused, the extruder simultaneously moved up and diagonally, moving away from the model, and then drove home along X and Y)
When pressed back, the extruder returned to the model and printed it further.
Now, actually, the question is: is it possible to make the same pause and change of filament on Marlin firmware?