Hi all,
Sorry if this has been asked. I did do a search and didn't find anything.
OK I have a Ender 3 with the SKR Mini (E3V 1.2) motherboard, and I'm having a couple of issues I am hoping y'all can help me fix.
I'll post a copy of the current firmware and upgrades I have done.
So when I try to print something I have to turn the hot end all the way up. For example: The firmament I am using (Hatchbox PLA) "acts" like it has a clog till I turn it up to too 260. When I first got it the temp would be fine. As I have use it the temp needs to be raised to point where I can only print as 260. No matter the filament.
Here's my nebie thoughts. I need a new hot end??? Or E-Stepper motor?? Or software? ...I know a new printer lol
I have updated the firmware to the one post but I am still having the same issuse.
Hardware or software?
I also ran test today and told it to extrude 100mm after I measured it and it was 104mm. So it's pushing out to much filament.
Any ideas?
Settings:
Cura slicer
Temp: 260
Plate: 60
Speed: 50mm S
Layer: .01
Tip: .4
Feed Rate: 113% (set before new feed rate was discovered)
Retraction: 8
Retraction Speed: 80
Upgrades:
Aluminum Extruder
SRK Mini
Glass Bed
Yellow Springs with Lock Nuts
Bulls eye cooling system
LED light bar.
Winsinn 24v 40mm fans (3)
Printed blue V slot rails
I tried to think of everything you would need to help troubleshot. If you need any more info please ask and I"ll get it posted.
TIA
James
Sorry if this has been asked. I did do a search and didn't find anything.
OK I have a Ender 3 with the SKR Mini (E3V 1.2) motherboard, and I'm having a couple of issues I am hoping y'all can help me fix.
I'll post a copy of the current firmware and upgrades I have done.
So when I try to print something I have to turn the hot end all the way up. For example: The firmament I am using (Hatchbox PLA) "acts" like it has a clog till I turn it up to too 260. When I first got it the temp would be fine. As I have use it the temp needs to be raised to point where I can only print as 260. No matter the filament.
Here's my nebie thoughts. I need a new hot end??? Or E-Stepper motor?? Or software? ...I know a new printer lol
I have updated the firmware to the one post but I am still having the same issuse.
Hardware or software?
I also ran test today and told it to extrude 100mm after I measured it and it was 104mm. So it's pushing out to much filament.
Any ideas?
Settings:
Cura slicer
Temp: 260
Plate: 60
Speed: 50mm S
Layer: .01
Tip: .4
Feed Rate: 113% (set before new feed rate was discovered)
Retraction: 8
Retraction Speed: 80
Upgrades:
Aluminum Extruder
SRK Mini
Glass Bed
Yellow Springs with Lock Nuts
Bulls eye cooling system
LED light bar.
Winsinn 24v 40mm fans (3)
Printed blue V slot rails
I tried to think of everything you would need to help troubleshot. If you need any more info please ask and I"ll get it posted.
TIA
James