Hi Everyone,
I am relative new to 3d printing and have some (actually a lot of) questions. But this time I would like to ask help regarding absolute zero height. Let me explain a bit:
I long term I would like to use bltouch with ABL. I will have more question regarding this later but at the moment I wanted to do the initial bed leveling manually using the "paper method". After doing some G28 and G29 according to the result I had to lift the bed a bit. But probably my springs under the bed loose now so I at the maximum height. I thought I will lower the whole bed for example approximately 2 mm and move also the absolute 0 height on my printer. But I cannot find any way to move the 0 height down. I'm using SKR 1.4 turbo with bltouch attached to the probe connector not in the z min connector. From this point the Z end switch does nothing. I assume there is an absolute zero height set somewhere as the bltouch can only measure relative height to the bed. Where can I set the whole nozzel's zero level? (I'm only able to find the Probe's Z offset which is do nothing in regarding this.)
Thank you in advance!
I am relative new to 3d printing and have some (actually a lot of) questions. But this time I would like to ask help regarding absolute zero height. Let me explain a bit:
I long term I would like to use bltouch with ABL. I will have more question regarding this later but at the moment I wanted to do the initial bed leveling manually using the "paper method". After doing some G28 and G29 according to the result I had to lift the bed a bit. But probably my springs under the bed loose now so I at the maximum height. I thought I will lower the whole bed for example approximately 2 mm and move also the absolute 0 height on my printer. But I cannot find any way to move the 0 height down. I'm using SKR 1.4 turbo with bltouch attached to the probe connector not in the z min connector. From this point the Z end switch does nothing. I assume there is an absolute zero height set somewhere as the bltouch can only measure relative height to the bed. Where can I set the whole nozzel's zero level? (I'm only able to find the Probe's Z offset which is do nothing in regarding this.)
Thank you in advance!