Hi guys,
This is my first post here.
Please help to understand the following issue.
I have RigidBot 3D Printer ( Cartesian, 250x250x250, single extruder, no probes )
Successfully configured and installed Marlin 1.1.9 on it
Decided to go with Marlin 2.0.X
Well it did not go as smooth as I wanted to be:
I'm skipping all marazm with getting it compiled ( virtual studio + platformio + marlinauto + and so on )
Straight to the problem:
When I use 1.1.9 all my stepper direction is fine ( homing and linear moves )
When ported all the same setting to Marlin 2.0.7.2 based firmware homing direction is reversed but manual travel direction is fine ( G1 X Y Z is fine too )
I was bashing my head and cannot wrap my brain around what is going on, It just suppose to work. I did not change stepper wiring in any way. I can flash 1.1.9 back and it work as a charm.
What Am I missing ?
I included 2 config files ( 1.1.9 based and 2.0.7.2 based )
May be you can spot the problem?
Thank you
This is my first post here.
Please help to understand the following issue.
I have RigidBot 3D Printer ( Cartesian, 250x250x250, single extruder, no probes )
Successfully configured and installed Marlin 1.1.9 on it
Decided to go with Marlin 2.0.X
Well it did not go as smooth as I wanted to be:
I'm skipping all marazm with getting it compiled ( virtual studio + platformio + marlinauto + and so on )
Straight to the problem:
When I use 1.1.9 all my stepper direction is fine ( homing and linear moves )
When ported all the same setting to Marlin 2.0.7.2 based firmware homing direction is reversed but manual travel direction is fine ( G1 X Y Z is fine too )
I was bashing my head and cannot wrap my brain around what is going on, It just suppose to work. I did not change stepper wiring in any way. I can flash 1.1.9 back and it work as a charm.
What Am I missing ?
I included 2 config files ( 1.1.9 based and 2.0.7.2 based )
May be you can spot the problem?
Thank you