I have a Sapphire Plus, which I have flashed Marlin firmware to enable various features, such as manual Mesh Bed Leveling.
Every time the printer starts, the Bed Level option is hidden. I have to manually run "Auto Home" to make it visible, then change it from OFF (default) to ON.
I do have "#define RESTORE_LEVELING_AFTER_G28" uncommented/active, but from further reading it appears that this line simply enables persistent memory of existing mesh values, rather than enable the "Bed Leveling" feature entirely.
What can I do to make the printer boot with "Bed Leveling" on by default?
Every time the printer starts, the Bed Level option is hidden. I have to manually run "Auto Home" to make it visible, then change it from OFF (default) to ON.
I do have "#define RESTORE_LEVELING_AFTER_G28" uncommented/active, but from further reading it appears that this line simply enables persistent memory of existing mesh values, rather than enable the "Bed Leveling" feature entirely.
What can I do to make the printer boot with "Bed Leveling" on by default?