Hello all,
I just installed an SKR 1.4 Turbo TMC 2208 on my Ender 3 V2 in order to add dual extrusion to the beast :D
After struggling with the screen (see first thread on this forum), I finally woke it out with the good help of Dust.
I also managed to have the steppers run in the right way and the BLTOUCH to perform correctly the probing of the bed.
However, the Extruders are not available despite being plugged correctly, I see an extruder in the LCD "move" menu but changing the value doesn't make the extruder to run, they both stand still.
How can I proceed to see E0 and E1 in the LCD menu ?
Would be good to also manage to see some tools like Z-offset tool, any idea ?
![IMG-1646.jpg]( "IMG-1646.jpg")
![IMG-1647.jpg]( "IMG-1647.jpg")
I just installed an SKR 1.4 Turbo TMC 2208 on my Ender 3 V2 in order to add dual extrusion to the beast :D
After struggling with the screen (see first thread on this forum), I finally woke it out with the good help of Dust.
I also managed to have the steppers run in the right way and the BLTOUCH to perform correctly the probing of the bed.
However, the Extruders are not available despite being plugged correctly, I see an extruder in the LCD "move" menu but changing the value doesn't make the extruder to run, they both stand still.
How can I proceed to see E0 and E1 in the LCD menu ?
Would be good to also manage to see some tools like Z-offset tool, any idea ?
