Another servo question I can't seem to find any explanation is the DISSABLE_SERVOS_AFTER_MOVE. Does this work with the SKR V1.4 board and what does it do?
From what I found it is supposed to shut off the 5V for the servos. The only dedicated servo port is for the bltouch and I don't want to shut that off. I plan on defining another pin for use with a second servo. Is there a controllable 5V pin for servo power or would I need to define some pin to use for a relay to control the power to servo.
I can't yet find anything on what the DISSABLE_SERVOS_AFTER_MOVE actually does and how to use it.
I've searched for an explanation but have had no luck yet. I wish there was some better docs on Marlin that explained some of these options.
Thanks
From what I found it is supposed to shut off the 5V for the servos. The only dedicated servo port is for the bltouch and I don't want to shut that off. I plan on defining another pin for use with a second servo. Is there a controllable 5V pin for servo power or would I need to define some pin to use for a relay to control the power to servo.
I can't yet find anything on what the DISSABLE_SERVOS_AFTER_MOVE actually does and how to use it.
I've searched for an explanation but have had no luck yet. I wish there was some better docs on Marlin that explained some of these options.
Thanks