Hello
Recently did a bit of wiring work and uprgrade to a skr1.4 turbo with 2208 drivers. I've also installed 0.9 degree motors on the X & Y.
The config I've made from a virgin Marlin bugfix seems to be working a treat in most part. However, I've hit a brick wall when it comes to the bed levelling.
Homing works well. X and Y triggers and the bltouch serves as the z probe. When i auto home, it hits x and y endstops and moves to the z safe homing position,x150 y150 which is what i expected.
However...When i run a bilinear bed running command it moves to the 0,0 corner and starts to probe out the grid. Strange thing is... the grid stays within a 150 150 square and probes 3 x 3 in the bottom left quadrant only.
First time configuring a config, also wiring. Lots of fun and I've learnt more from troubleshooting than I would have if I had not had issues. Im assuming that im missing something simple here ha
I've attached my config files for review. Worth noting I've adjusted my y and x steps to 160 as per calculation on the prusa website. (400 steps 2mm pitch 20 teeth)
I hope you're all well
TDLR Im super confused.The bed dimensions entered into marlin work great in regards to Auto Home. But when i auto bed level it thinks the bed is a 1/4 of the size it is and levels the bottom left corner only instead.
Recently did a bit of wiring work and uprgrade to a skr1.4 turbo with 2208 drivers. I've also installed 0.9 degree motors on the X & Y.
The config I've made from a virgin Marlin bugfix seems to be working a treat in most part. However, I've hit a brick wall when it comes to the bed levelling.
Homing works well. X and Y triggers and the bltouch serves as the z probe. When i auto home, it hits x and y endstops and moves to the z safe homing position,x150 y150 which is what i expected.
However...When i run a bilinear bed running command it moves to the 0,0 corner and starts to probe out the grid. Strange thing is... the grid stays within a 150 150 square and probes 3 x 3 in the bottom left quadrant only.
First time configuring a config, also wiring. Lots of fun and I've learnt more from troubleshooting than I would have if I had not had issues. Im assuming that im missing something simple here ha
I've attached my config files for review. Worth noting I've adjusted my y and x steps to 160 as per calculation on the prusa website. (400 steps 2mm pitch 20 teeth)
I hope you're all well
TDLR Im super confused.The bed dimensions entered into marlin work great in regards to Auto Home. But when i auto bed level it thinks the bed is a 1/4 of the size it is and levels the bottom left corner only instead.