I got a kit a few years back. finally put it together it is a flsun c plus with touchscreen, dual extruder, and autoleveling. It seems to be one of the i3 clones with a bild area of 300x300x420.
Put it together finally and things aren't working remotely right. followed suggestion from someone online and flashed the firmware onto it again from the sd card that came with it. printer completely screwed up now soI look online. foundnd someone that has this printer without dual extruders and got their firmware and managed to get that working mostly after a good deal of fighting. So then I set upon the task of getting the 2nd extruder working.
I have made some progress in that i now have the second heater and the temp sensor working, but I cannot seem to get the second extruder to actually work. I have attached the config file here. If someone could look it over and help I'd be grateful. I have the chimaera head where there are two separate blocks, heaters, and nozzles if that makes a difference
Put it together finally and things aren't working remotely right. followed suggestion from someone online and flashed the firmware onto it again from the sd card that came with it. printer completely screwed up now soI look online. foundnd someone that has this printer without dual extruders and got their firmware and managed to get that working mostly after a good deal of fighting. So then I set upon the task of getting the 2nd extruder working.
I have made some progress in that i now have the second heater and the temp sensor working, but I cannot seem to get the second extruder to actually work. I have attached the config file here. If someone could look it over and help I'd be grateful. I have the chimaera head where there are two separate blocks, heaters, and nozzles if that makes a difference