Hello I wonder if anyone can help me?
Ender 3 V2 and fitted an SKR 2 board/2209 steppers with TFT35 E3 v3 - BLTouch & Dual Z Axis (each on their own stepper)
2.0.9.1 Marlin compiled by myself.
The problem I'm having, is all the endstops seem to be getting ignored? A M119 shows they are working OK, but doing an 'Auto Home' results in all the axis grinding when they reach these points?, like it's trying to continue past the endstop marks? I have sensorless homing disabled.
Could someone maybe check my configs to see if I have missed something? I'm at my wits end!
One thing I did notice, is that with M119 command, it shows XYZ triggered when I test when pressing them, open when released, but it throws up a continuous error of 'Couldn't X:0 Y:0 Z:0'?
I'd be grateful for any help guys. Thank you.
Ender 3 V2 and fitted an SKR 2 board/2209 steppers with TFT35 E3 v3 - BLTouch & Dual Z Axis (each on their own stepper)
2.0.9.1 Marlin compiled by myself.
The problem I'm having, is all the endstops seem to be getting ignored? A M119 shows they are working OK, but doing an 'Auto Home' results in all the axis grinding when they reach these points?, like it's trying to continue past the endstop marks? I have sensorless homing disabled.
Could someone maybe check my configs to see if I have missed something? I'm at my wits end!
One thing I did notice, is that with M119 command, it shows XYZ triggered when I test when pressing them, open when released, but it throws up a continuous error of 'Couldn't X:0 Y:0 Z:0'?
I'd be grateful for any help guys. Thank you.