I just upgraded my Prusa i3 to have auto leveling, and although everything works fine when homing the Z axis it probes outside of my bed, rather then on the build plate (causing a crash). What firmware setting do I change to fix this?
In addition, when following Tom's guide (https://www.youtube.com/watch?v=EcGFLwj0pnA) he says to send G92Z10, to calibrate the extruder height - however this does not work for me. How do I do this?
Thanks in advance.
In addition, when following Tom's guide (https://www.youtube.com/watch?v=EcGFLwj0pnA) he says to send G92Z10, to calibrate the extruder height - however this does not work for me. How do I do this?
Thanks in advance.