SKR1.4 Turbo Dual X axes X2 not shown on M122 (no replies)

Hi All,

I have spent many hours trying to find what my issue X2 is not detected, I have TMC2209 and the drivers seem to work fine if I swap them they get detected.

Latest Marlin 2.0.9.3 version and earlier versions with same result.
Board BOARD_BTT_SKR_V1_4_TURBO
drivers: TMC2209
X2 is on E1 port

When I enable X_DUAL_STEPPER_DRIVERS the X2 is moving both X and X2 (even it seems to run on a different micro steps) but when I do a M122 it only shows X not X2 so I can't setup the current for X2

See M112

ENDING:M122
axis:pwm_scale/curr_scale/mech_load|flags|warncount
X Y Z
Address 0 0 0
Enabled false false false
Set current 900 800 800

and a bit later

Testing X connection... OK
Testing Y connection... OK
Testing Z connection... OK

but nothing about X2 or E1

Please find my configuration and configuration_adv attached I can't figure out why X2 is not showing.

Kind regards,

Jortijn