As the title says, I'm using a MKS Sbase V1.3 with a cheap printer running on Marlin Firmware successfully. However, as usual, the DRV 8825's are just too noisy, and I would like to use the external stepper motors driver boards on them. They are on the way, hence why I can't just plug and test. I searched and can't seem to find (there's one link to thingiverse with the author saying they just upgraded to 2208's) any thing on this.
Basically my question is this. Do I need to change anything in the Marlin Firmware so that the MKS Sbase V1.3 board knows to use the external stepper board? I can't seem to find anything in configuration.h or configuration_adv.h or pins_MKS_SBASE.h that implies that. Is it enabled by default? Thanks!
Basically my question is this. Do I need to change anything in the Marlin Firmware so that the MKS Sbase V1.3 board knows to use the external stepper board? I can't seem to find anything in configuration.h or configuration_adv.h or pins_MKS_SBASE.h that implies that. Is it enabled by default? Thanks!