I,ve just about finished my build - currently using the Reprap Smart graphics Controller - all works o.k.
However, my intention was to use a MKS32 TFT Touchscreen - but I simply cannot get it to work!
It boots o.k. and shows the icons, I can select then and move through the 'menu' - however, they have no impact on the stepper motors or any other function.
The MKS frmware is up to date, set to Marlin, the baud rate set to the same as the motherboard - the MKS32 connected to the AUX connector on the SKR1.3.
Is there something I have to uncomment /define in Marlin in the graphics controller section in configuration.h?
Any advice much appreciated.
However, my intention was to use a MKS32 TFT Touchscreen - but I simply cannot get it to work!
It boots o.k. and shows the icons, I can select then and move through the 'menu' - however, they have no impact on the stepper motors or any other function.
The MKS frmware is up to date, set to Marlin, the baud rate set to the same as the motherboard - the MKS32 connected to the AUX connector on the SKR1.3.
Is there something I have to uncomment /define in Marlin in the graphics controller section in configuration.h?
Any advice much appreciated.