Hi, I have a cura Ultimaker Original and due to some problems with the extruder, a friend tried loading a new Marlin configuration and, in short, he failed and the printer would not start at all.
So I decided to do it myself and went through the learning process, I searched for the original configuration files in the Marlin github, compiled them and loaded them to the printer. Using Marlin 2.0 from here: [github.com], and config files for Ultimaker Original from here: [github.com], which seem to be the same as: [github.com]
However, now I start the printer but it seems to load the initial screen and immediately resets itself, bringing back the screen and resetting again in an endless cycle.
I can see the reset button on the Arduino board is flashing, but have no idea where to look in the configuration files for something that can be causing this.
I would appreciate any help on what direction I can take to solve this problem, or ideas of keywords to search in this forum, so far I have only thought of "reset", "resseting" mixed with Arduino or Marlin, but without success.
Originally, the printer would start and I could preheat, start a print, etc. but the extruder motor would not move, but can´t see how that would be related to the issue with the new config.
So I decided to do it myself and went through the learning process, I searched for the original configuration files in the Marlin github, compiled them and loaded them to the printer. Using Marlin 2.0 from here: [github.com], and config files for Ultimaker Original from here: [github.com], which seem to be the same as: [github.com]
However, now I start the printer but it seems to load the initial screen and immediately resets itself, bringing back the screen and resetting again in an endless cycle.
I can see the reset button on the Arduino board is flashing, but have no idea where to look in the configuration files for something that can be causing this.
I would appreciate any help on what direction I can take to solve this problem, or ideas of keywords to search in this forum, so far I have only thought of "reset", "resseting" mixed with Arduino or Marlin, but without success.
Originally, the printer would start and I could preheat, start a print, etc. but the extruder motor would not move, but can´t see how that would be related to the issue with the new config.