Overview of issue:
Hey so I am pretty close to successfully updating the mainboard and thus the firmware on my Monoprice mini delta. However when I try to do input a G33 command, the printer homes, then the effector moves down about halfway, then makes its way bit by bit to the top where it once again homes, then moves only one axis down moderately fast and it fails saying error probing failed. fix delta parameters with M665 and M666.
-If I try to increase the delta height value it only goes a tiny bit more down (I have tried changing it from 110mm the default all the way to 200mm)
-I have saved the settings to eeprom
-The steps/mm values for the xyz are all set correctly. I have measured the actual/inputted movement to make sure.
So I'm not sure exactly what is happening here. I can't find anything on the subject so any bit of help would be great!
I have attached the configuration.h and configurationadv.h files that have all of the settings configured to eeprom
Please and Thank You
Hey so I am pretty close to successfully updating the mainboard and thus the firmware on my Monoprice mini delta. However when I try to do input a G33 command, the printer homes, then the effector moves down about halfway, then makes its way bit by bit to the top where it once again homes, then moves only one axis down moderately fast and it fails saying error probing failed. fix delta parameters with M665 and M666.
-If I try to increase the delta height value it only goes a tiny bit more down (I have tried changing it from 110mm the default all the way to 200mm)
-I have saved the settings to eeprom
-The steps/mm values for the xyz are all set correctly. I have measured the actual/inputted movement to make sure.
So I'm not sure exactly what is happening here. I can't find anything on the subject so any bit of help would be great!
I have attached the configuration.h and configurationadv.h files that have all of the settings configured to eeprom
Please and Thank You