hi,
The situation is when I turn Linear Advance ON in marlin, the machine gets KILLED seconds later as print started.
I have no idea what could be wrong, TMC2208 drivers on the board.
Did anyone have the same or similar experience or can think of where should I look the solution for?
I was thinking to switch on the debugging mode, to see some detailed information in the Pronterface terminal, but earlier I tried this function and to be honest, the printer movements were disturbed so much! (as I read this function takes a lot of mem.)
Thank for all your reply.
The situation is when I turn Linear Advance ON in marlin, the machine gets KILLED seconds later as print started.
I have no idea what could be wrong, TMC2208 drivers on the board.
Did anyone have the same or similar experience or can think of where should I look the solution for?
I was thinking to switch on the debugging mode, to see some detailed information in the Pronterface terminal, but earlier I tried this function and to be honest, the printer movements were disturbed so much! (as I read this function takes a lot of mem.)
Thank for all your reply.