UBL never worked for me well, or at all.
This is the case again, so I have tried ABL. It works well but not 100% and there is no possibility for manual adjustment of the grid, as far as I see. (If I am wrong let me know)
At least it does the correction, however still not great at one side of the bed. 90% of the bed is OK but not the right side and I cannot do so much about it.
I am using BLTouch on all my printers. (well, it is not true, one is manual because I was a bit pissed off and take the sensor off :D :D :D )
So, I tried again UBL on my modified CR10 MAX because I want a perfect level. Some of our models are huge, but not high, so good levelling is very important. Also, I have no time to check the printer after it starts printing. With 6-7 printers it is not livable :D I want good printers and I am working hard to reach this point. So far, in the last 2 years, I never needed help, I could figure out almost everything by myself. - Plenty of help on the net but not for everything. Most of the material is for beginners, and it is great, but not helpful for me anymore.
However, now, this "UBL does nothing" syndrome, well, it testing my patience :D . Z doesn't move a bit at printing.
Of course, I have saved the mesh, L0, activated, I know Gcode and using it in my start gcode (G29 L0 / G29 J2) in slicer or I write it in manually :D whatever.
So I cannot see a mistake or problem here. In pronterface I re-check the mesh, and everything looks OK.
However, it is NOT.
And to be honest, I have no idea what can be wrong if it is not Marlin or the Board itself. I cannot find any thread with the correct solution for this.
Thank you for your help.
This is the case again, so I have tried ABL. It works well but not 100% and there is no possibility for manual adjustment of the grid, as far as I see. (If I am wrong let me know)
At least it does the correction, however still not great at one side of the bed. 90% of the bed is OK but not the right side and I cannot do so much about it.
I am using BLTouch on all my printers. (well, it is not true, one is manual because I was a bit pissed off and take the sensor off :D :D :D )
So, I tried again UBL on my modified CR10 MAX because I want a perfect level. Some of our models are huge, but not high, so good levelling is very important. Also, I have no time to check the printer after it starts printing. With 6-7 printers it is not livable :D I want good printers and I am working hard to reach this point. So far, in the last 2 years, I never needed help, I could figure out almost everything by myself. - Plenty of help on the net but not for everything. Most of the material is for beginners, and it is great, but not helpful for me anymore.
However, now, this "UBL does nothing" syndrome, well, it testing my patience :D . Z doesn't move a bit at printing.
Of course, I have saved the mesh, L0, activated, I know Gcode and using it in my start gcode (G29 L0 / G29 J2) in slicer or I write it in manually :D whatever.
So I cannot see a mistake or problem here. In pronterface I re-check the mesh, and everything looks OK.
However, it is NOT.
And to be honest, I have no idea what can be wrong if it is not Marlin or the Board itself. I cannot find any thread with the correct solution for this.
Thank you for your help.