I lost my old and well working Marlin bugfix-2.0.xxxx.... ( i dont know). So I decided to use the newest. So far so good, but I have a strange problem and IDK where I can change that in the firmware.
Before the print starts, the display shows the following info:
[attachment 120067 IMG_20230124_172436.jpg]
Then, when he is printing:
[attachment 120068 IMG_20230124_172510.jpg]
The first "100%" is clear, but what the heck is the second "100%" ?
And the second thing is... why the heck is the elapsed printing time gone? Or where can I enable it in the firmware?
On my old firmware, there was a timer on the right hand side, which showed the elapsed print time.
Is active...
I print via Octoprint without an SD
Before the print starts, the display shows the following info:
[attachment 120067 IMG_20230124_172436.jpg]
Then, when he is printing:
[attachment 120068 IMG_20230124_172510.jpg]
The first "100%" is clear, but what the heck is the second "100%" ?
And the second thing is... why the heck is the elapsed printing time gone? Or where can I enable it in the firmware?
On my old firmware, there was a timer on the right hand side, which showed the elapsed print time.
#define PRINTJOB_TIMER_AUTOSTART
Is active...
I print via Octoprint without an SD