G28 X does not home the X axis (4 replies)

Hi there,

I have a classic Ender 3.
Running Marlin-2.1.1 on a BTT SKR v1.3 board with TMC 2130 drivers.
Wifi connected with ESP3D on a ESP32-CAM board connected to TFT port.

Note: X endstop is on the left side.
When I send G28 or G28 X, the hotend do not home properly.
Rather the hot end just move a little to the right side (like 3mm) and stops.
So if I keep on sending G28 X, the hot end just moves little by little to the right side.
configuration files