Y2 end stop is not recognized (1 reply)

Hello, i have dual y motors that run independently of each other and both have their own end stops.

i did the following:

#define Y_DUAL_ENDSTOPS
  #if ENABLED(Y_DUAL_ENDSTOPS)
    #define Y2_USE_ENDSTOP _E1DIAG_
    #define Y2_ENDSTOP_ADJUSTMENT  0
  #endif
#endif

When i do an m119 everything is neatly "open" except y2 "triggers"
i have attached configuration files.
vriendelijk bedankt alvast voor het meedenken.

groet Edwin