Ran into a bit of a snag while homing X and Y axes separately in Marlin firmware. Each time I home X or Y individually, the Z-axis decides to take a 5mm stroll in the positive direction.
Any chance you could guide me on putting a stop to this Z-axis movement during separate homing of X and Y? I've delved into the settings, but the solution hasn't quite revealed itself.
Appreciate any insight you can share to help me tackle this puzzle.
Any chance you could guide me on putting a stop to this Z-axis movement during separate homing of X and Y? I've delved into the settings, but the solution hasn't quite revealed itself.
Appreciate any insight you can share to help me tackle this puzzle.