Hi everyone, I modified a home-built Prusa i3 by replacing the ramps1.4 with a MKS Tinybee V1.0, after several attempts I managed to configure it, the only thing I still can't do is connect to the printer via wifi.
Once turned on, it creates its MARLIN_ESP network, but from the browser by entering 192.168.0.1 as the address, I can't load the web interface, has anyone already encountered this problem?
Once turned on, it creates its MARLIN_ESP network, but from the browser by entering 192.168.0.1 as the address, I can't load the web interface, has anyone already encountered this problem?