Cannot resume print after pause (no replies)

Hey there,

I have the following printer setup:

ToAuto A 1.1 Pyramid (CR10 Clone basically) 300mmx300mx400mm build size
MKS Robin Nano V3.1 with TS35 Touchscreen LCD
X/Y/Z and Extruder steppers with TMC2209 stepper drivers
Marlin Firmware 2.1.2.1 (Should be the latest)

Attached is my configuration.h and configuration_adv.h files.

The problem is that if I pause the print, I cannot get the print to resume.

What happens is I see something going on I need to fix, need to change filament, etc ... so I use the touch screen to pause the print. The printer will go to the defined park position, X_Min_POS +5 and Y_Min_POS + 5, Z 100, beeps a couple times, and then just sits there waiting with the extruder and heated bed still holding temperature.

When I press the resume button either by using my finger to touch the button or the rotary wheel, nothing happens, it just sits there and never resumes the print.

Seems to be a common issue with Marlin firmware sometimes with specific touch screens when I was searching for an answer? Was wondering if maybe it has to do with the TS35 touch screen I have? OR maybe just a setting in my configuration files.

Thanks,
Nate