Hello, I have a question on where the Z_STEPPER_ALIGN_KNOWN_STEPPER_POSITIONS should be measured from/to.
I have a bed that is 535x535 with a printable area of 490x465. Z1 is -95,0 Z2 is 565,0 (+75 on x) and Z3 is 230, 645(+180 on y).
I think the probe points should within printable area and all on the same radius from the center of the circle created by the z axes...right?
I have a bed that is 535x535 with a printable area of 490x465. Z1 is -95,0 Z2 is 565,0 (+75 on x) and Z3 is 230, 645(+180 on y).
I think the probe points should within printable area and all on the same radius from the center of the circle created by the z axes...right?