So I got my bltouch working correctly thanks to Dust.
No my problem is my Z steppers when homing. They lock up when moving in Z+ after the 1st touch of the probe. It sounds like a belt slipping. It's a pretty ugly sound. I've tried a few different things but haven't zero'd in on the problem yet and hoping someone could point me in right direction.
Printer is a Makerfarm Pegasus. It's been working for years with Colins original firmware, but I have no idea which version of Marlin it was as the pc I did the original compiling on died years ago.
Ive attached my full config.h file.
I should mention that I wrote down all the settings I could find thru the lcd before I started on this project. However I was using the reprap discount graphic display versus the full graphic display now and with the newer firmware the verbage for the settings don't match and I don't know what some of them are.
Accel - 500
Vxy_jerk - 20
Vmax_X - 250
Y - 250
Z - 2
E - 22
Vmin - 0
Vtrav_min - 0
Amax_x - 1000
y - 1000
z - 5
e - 1000
A-retract - 500
Xsteps - 80
Ystesp - 80
Zsteps - 4000
Esteps - 411.8
Auto_temp - Off
Hotend min - 210
Hotend max - 250
Fact .1
Most I figured out and transferred them to my new config, but one or two I'm not sure what exactly they are. I did change my hotend min and max in new firmware as I know my E3D V6 hotend is rated for a higher temp then what Colin had them set for.
No my problem is my Z steppers when homing. They lock up when moving in Z+ after the 1st touch of the probe. It sounds like a belt slipping. It's a pretty ugly sound. I've tried a few different things but haven't zero'd in on the problem yet and hoping someone could point me in right direction.
Printer is a Makerfarm Pegasus. It's been working for years with Colins original firmware, but I have no idea which version of Marlin it was as the pc I did the original compiling on died years ago.
Ive attached my full config.h file.
I should mention that I wrote down all the settings I could find thru the lcd before I started on this project. However I was using the reprap discount graphic display versus the full graphic display now and with the newer firmware the verbage for the settings don't match and I don't know what some of them are.
Accel - 500
Vxy_jerk - 20
Vmax_X - 250
Y - 250
Z - 2
E - 22
Vmin - 0
Vtrav_min - 0
Amax_x - 1000
y - 1000
z - 5
e - 1000
A-retract - 500
Xsteps - 80
Ystesp - 80
Zsteps - 4000
Esteps - 411.8
Auto_temp - Off
Hotend min - 210
Hotend max - 250
Fact .1
Most I figured out and transferred them to my new config, but one or two I'm not sure what exactly they are. I did change my hotend min and max in new firmware as I know my E3D V6 hotend is rated for a higher temp then what Colin had them set for.