Since I'm such a noob at this, maybe I'm asking the wrong question. Is there something in my config that would cause or allow an incorrect thermal runaway error?
I can't see to get this to be stable. It doesn't matter the size of the print it prints about 4-6 layers then the fast beep, thermal runaway message for the extruder and the firmware resets. This is driving me bonkers.
I can't see to get this to be stable. It doesn't matter the size of the print it prints about 4-6 layers then the fast beep, thermal runaway message for the extruder and the firmware resets. This is driving me bonkers.