hi i'm not super profession on the firmware, know a bit but not enough
help needed on this error
i'm in the process of eventually upgrading from marlin v1.0.0. to marlin 2.1.2.5
had a few issues but most sorted, now having problem when heating the bed i get this error
"Heating Failed: Bed. PRINTER HALTED, Please Reset"
as i have a 6mm glass on top of my head bed takes bit longer to heat up, especially for get 100 Deg for the ABS, when i start getting heating to 80+ deg i get this message
it is as the new firmware expects heating to happen faster, but in my case is slow due to heating the 6mm glass ontop of the heat bead
is ther a setting in the firmware whereby i can increase the monitor time on the heating process ..
Not sure if this is causing this heating error
you help will be greatly appreciated
help needed on this error
i'm in the process of eventually upgrading from marlin v1.0.0. to marlin 2.1.2.5
had a few issues but most sorted, now having problem when heating the bed i get this error
"Heating Failed: Bed. PRINTER HALTED, Please Reset"
as i have a 6mm glass on top of my head bed takes bit longer to heat up, especially for get 100 Deg for the ABS, when i start getting heating to 80+ deg i get this message
it is as the new firmware expects heating to happen faster, but in my case is slow due to heating the 6mm glass ontop of the heat bead
is ther a setting in the firmware whereby i can increase the monitor time on the heating process ..
Not sure if this is causing this heating error
you help will be greatly appreciated