Is there a step by step set of instructions for using UBL? I'm using 1.1.0 with a BLTouch. Following the steps I think I need I initialized EEPROM, did a G29 P1 to create a mesh and saved it to EEPROM with G29 S0.
I activate UBL, load the mesh and then try to print but there is no obvious correction taking place. The only time Z moves is when changing layers.
Anything else do I need to do in my start print script?
I activate UBL, load the mesh and then try to print but there is no obvious correction taking place. The only time Z moves is when changing layers.
Anything else do I need to do in my start print script?