So trying my hand at configuring 1.1.1 but the documentation is not up to date as I bet most everyone is aware :)
Also I am pretty much a newbie.
I have almost everything working but I have an issue with G28 homing. The system is moving the z axis away from home before it homes x/y and then it homes Z
On most units I can see why, but on my unit its my Bed that moves on Z so I always have it near the bottom of its travel from when I was removing my last print.
In this case I always end up with it crashing into the bottom outside of physical travel limits.
I would like to disable this but I cant find it in the configuration.h file.
Can anyone help?
Thanx
Also I am pretty much a newbie.
I have almost everything working but I have an issue with G28 homing. The system is moving the z axis away from home before it homes x/y and then it homes Z
On most units I can see why, but on my unit its my Bed that moves on Z so I always have it near the bottom of its travel from when I was removing my last print.
In this case I always end up with it crashing into the bottom outside of physical travel limits.
I would like to disable this but I cant find it in the configuration.h file.
Can anyone help?
Thanx