Hi, I finally installed auto inductive sensor 4mm or 8mm , can't remember now.
We'll now what, how do make my 3d printer do a auto leveI before print somenthing, how do adjust the nozzle if it's to close or to high after the auto level??
One thing on the new firmware, I try it the manual level mode , I was able to setup the nozzle , around the bed but like I ask above don't know how to save it or how to use it for a print job, some help please.
I use Cura 15. 3d slicing and repetier-host.
Marlin firmware 1.1
We'll now what, how do make my 3d printer do a auto leveI before print somenthing, how do adjust the nozzle if it's to close or to high after the auto level??
One thing on the new firmware, I try it the manual level mode , I was able to setup the nozzle , around the bed but like I ask above don't know how to save it or how to use it for a print job, some help please.
I use Cura 15. 3d slicing and repetier-host.
Marlin firmware 1.1