Hello,
i own a tevo tarantula and recenitly i installed a proximity sensorand upgraded the firmware.
for some reason, the mesh leveling doesnt work.
its very easy to see that one corner of the print have the right distance between the nozzle and the bed, while another corner is not at the right distance.
the printer starts by homing all axis and then in mesure the bed in 9 different points.
im using cura, my start code is:
G28
G29
M107
M140 S60
M104 S210
z offset is -0.31
does anyone have an idea why it doesnt do a proper meshing?
i own a tevo tarantula and recenitly i installed a proximity sensorand upgraded the firmware.
for some reason, the mesh leveling doesnt work.
its very easy to see that one corner of the print have the right distance between the nozzle and the bed, while another corner is not at the right distance.
the printer starts by homing all axis and then in mesure the bed in 9 different points.
im using cura, my start code is:
G28
G29
M107
M140 S60
M104 S210
z offset is -0.31
does anyone have an idea why it doesnt do a proper meshing?