Hello, I made a custom 3D printer and got everything to work except bed leveling. I currently am doing PROBE_MANUALLY with MESH_BED_LEVELING and LCD_BED_LEVELING. I am using a Ramps 1.4 with Marlin and the LCD screen.
I can follow the on-screen instructions and the printer moves throughout the bed leveling points. I adjust the Z-axis, use a piece of paper, all of that. After bed leveling, I use Pronterface to send the code M420 S1 to enable bed leveling. I then use Cura to create the Gcode which I again send with Pronterface.
The problem is that the bed leveling does not seem to have any effect. To test it, I "leveled" the bed by setting the nozzle 5mm above the bed at all calibration points. Yet when I run the print, the nozzle is almost touching the buildplate as that is the zero point on the Z-axis.
What am I missing that would enable the bed leveling to work? I have attached my Configuration.h and Configuration_adv.h
I'd really appreciate any help, I've tried all sorts of combinations of settings but keep getting the same result. Thanks in advance!
I can follow the on-screen instructions and the printer moves throughout the bed leveling points. I adjust the Z-axis, use a piece of paper, all of that. After bed leveling, I use Pronterface to send the code M420 S1 to enable bed leveling. I then use Cura to create the Gcode which I again send with Pronterface.
The problem is that the bed leveling does not seem to have any effect. To test it, I "leveled" the bed by setting the nozzle 5mm above the bed at all calibration points. Yet when I run the print, the nozzle is almost touching the buildplate as that is the zero point on the Z-axis.
What am I missing that would enable the bed leveling to work? I have attached my Configuration.h and Configuration_adv.h
I'd really appreciate any help, I've tried all sorts of combinations of settings but keep getting the same result. Thanks in advance!