Can some one test if thermal runaway is working in bugfix1.1.x?
Right now I do not have much connected to my controller basically only Themister and LCD with Encoder and SDCard. I set the temp to 1. It is reading the room temp at 23. I would think after a short time I should get a thermal runaway error. I do get a Heating failed when I set the temp 50 and the temp is 23 in the room.
Thermal Protection is enable and #define THERMAL_PROTECTION_PERIOD 40 and #define THERMAL_PROTECTION_HYSTERESIS 4
I have started over a couple times now configuring the board and this last time I setup only the basics to make sure I was not breaking something.
both configuration and configuration_adv from bugfix 1.1.x. But I did not touch anything in the adv file this last time.
[attachment 106348 Configuration.h]
[attachment 106349 Configuration_adv.h]
Right now I do not have much connected to my controller basically only Themister and LCD with Encoder and SDCard. I set the temp to 1. It is reading the room temp at 23. I would think after a short time I should get a thermal runaway error. I do get a Heating failed when I set the temp 50 and the temp is 23 in the room.
Thermal Protection is enable and #define THERMAL_PROTECTION_PERIOD 40 and #define THERMAL_PROTECTION_HYSTERESIS 4
I have started over a couple times now configuring the board and this last time I setup only the basics to make sure I was not breaking something.
both configuration and configuration_adv from bugfix 1.1.x. But I did not touch anything in the adv file this last time.
[attachment 106348 Configuration.h]
[attachment 106349 Configuration_adv.h]