I updated yesterday from Marlin 1.1.8 to 1.1.9 and 2.0.
The printer is a Ender 3, with stock creality melzi board.
I have Autobedleveling active with a inductive sensor in parallel to the z-endstop.
I noticed a different behavior when homing:
In 1.1.8, the nozzle homed. After hitting the Z-Endstop twice, the nozzle was driven up about 10mm, it rested way higher than the bed.
In 1.1.9, after homing and hitting z-end twice, the Arm rests on the z-endstop.
2.0 bugfix yesterday shows the same behavior as 1.1.9.
In all versions I could do a initialize EEPROM, which should clear any preset values including home offset.
But only in 1.1.8 I got this 10mm above z-endstop, not in 1.1.9 or 2.0 even with initializing.
How do I get back the behavior of 1.1.8? I would like to have the nozzle resting at a height of 10mm after homing.
The printer is a Ender 3, with stock creality melzi board.
I have Autobedleveling active with a inductive sensor in parallel to the z-endstop.
I noticed a different behavior when homing:
In 1.1.8, the nozzle homed. After hitting the Z-Endstop twice, the nozzle was driven up about 10mm, it rested way higher than the bed.
In 1.1.9, after homing and hitting z-end twice, the Arm rests on the z-endstop.
2.0 bugfix yesterday shows the same behavior as 1.1.9.
In all versions I could do a initialize EEPROM, which should clear any preset values including home offset.
But only in 1.1.8 I got this 10mm above z-endstop, not in 1.1.9 or 2.0 even with initializing.
How do I get back the behavior of 1.1.8? I would like to have the nozzle resting at a height of 10mm after homing.