Hi, I have a problem after updating Merlin from version 1.1.8 to version 1.1.9.
I have used the same parameters from the Configuration.h and Configuration_adv.h files of the older version,
but the AUTO_BED_LEVELING_BILINEAR behaves badly with the new firmware.
Homing and axis movements work correctly with the new firmware, the problem occurs when I try the bed leveling, the y axis moves to position 0, but when it has to increase it does not work, it seems that the stepper motor runs in the opposite direction.
My printer is a HICTOP 3DP11 Prusa i3.
In this video we see the behavior of the printer.
[www.youtube.com]
Has anyone encounter the problem or have any advice for me?
Thanks
I have used the same parameters from the Configuration.h and Configuration_adv.h files of the older version,
but the AUTO_BED_LEVELING_BILINEAR behaves badly with the new firmware.
Homing and axis movements work correctly with the new firmware, the problem occurs when I try the bed leveling, the y axis moves to position 0, but when it has to increase it does not work, it seems that the stepper motor runs in the opposite direction.
My printer is a HICTOP 3DP11 Prusa i3.
In this video we see the behavior of the printer.
[www.youtube.com]
Has anyone encounter the problem or have any advice for me?
Thanks