Hello. I'm reading this forum for a while but now I have a problem with a printer mod. I'm talking about: [www.thingiverse.com]
I have made the hardware part some months ago and then I was used Marlin/skynet. Now I'm using v.1.1.9 and I have problems with implement this mod in new marlin.
Can someone tell me generally which part should I change to use 2004 LCD with I2C controler and encoder? I try to understand marlin but it's very hard. I don't wont to destroy the MOBO or something else. I have make some try but with no success, to change something is wors than write it from begining :/
I have made the hardware part some months ago and then I was used Marlin/skynet. Now I'm using v.1.1.9 and I have problems with implement this mod in new marlin.
Can someone tell me generally which part should I change to use 2004 LCD with I2C controler and encoder? I try to understand marlin but it's very hard. I don't wont to destroy the MOBO or something else. I have make some try but with no success, to change something is wors than write it from begining :/