Hello
I have a problem with inductive probe. I had it working before but now i upgraded to skr board and it doesnt trigger.
I switched off pull up resistor, Probe sends signal because if i put it into temperature reading pin, it reads as 94 degrees and -14 when triggering. But when in zmin pin it alsways stays active. If i put Y endstop to zmin pin it works.
I have attached my conf files.
Does anyone have any ideas about why this happens?
I have a problem with inductive probe. I had it working before but now i upgraded to skr board and it doesnt trigger.
I switched off pull up resistor, Probe sends signal because if i put it into temperature reading pin, it reads as 94 degrees and -14 when triggering. But when in zmin pin it alsways stays active. If i put Y endstop to zmin pin it works.
I have attached my conf files.
Does anyone have any ideas about why this happens?