Just wondering if sanity checks for z-min exists in 1.1.9.
z-min error
my prob be normally closed, only opens when it touches the bed, so before a bed level is executed, check if prob signal is closed.
currently the fw still tries to level even if the prob signal is already open, causing the head to continuously trying to move up even ignoring the max endstops and crashing.
on my stock oem fw, if i try to level with the prob open, it'll beep and display z-min error.
So i'm wondering if this is an feature that is removed since 1.0.0, or something my oem customized?
another side question: is there a easier way to adjust z-height/offset in 1.1.9?
while i can adjust it in the probe z offset setting, I have to know the value beforehand.
on my stock oem fw, when i try to adjust the z-height, the head will actually move the the height displayed, thus i don't need to know the value beforehand, and i can just adjust it on the fly.
z-min error
my prob be normally closed, only opens when it touches the bed, so before a bed level is executed, check if prob signal is closed.
currently the fw still tries to level even if the prob signal is already open, causing the head to continuously trying to move up even ignoring the max endstops and crashing.
on my stock oem fw, if i try to level with the prob open, it'll beep and display z-min error.
So i'm wondering if this is an feature that is removed since 1.0.0, or something my oem customized?
another side question: is there a easier way to adjust z-height/offset in 1.1.9?
while i can adjust it in the probe z offset setting, I have to know the value beforehand.
on my stock oem fw, when i try to adjust the z-height, the head will actually move the the height displayed, thus i don't need to know the value beforehand, and i can just adjust it on the fly.