I have an offset bed probe, on my printer an IR one.
But my one problem with the G33 routine, is that it does not take into account the offset of the probe, and I assume there is a reason for this, if that is the case.
I’m looking to fit 3 offset probes to the effector and probe the XYZ offsets for each tower .
How hard would it be to implement this, and then overlay the 3 probe tables to produce a more accurate calibration.
I would do it myself but I would not know where to start to make the changes to marlin.
Regards
Paul
But my one problem with the G33 routine, is that it does not take into account the offset of the probe, and I assume there is a reason for this, if that is the case.
I’m looking to fit 3 offset probes to the effector and probe the XYZ offsets for each tower .
How hard would it be to implement this, and then overlay the 3 probe tables to produce a more accurate calibration.
I would do it myself but I would not know where to start to make the changes to marlin.
Regards
Paul