Head does not move in x and y when trying to build UBL mesh (probes in same place repeatedly) (3 replies)

Hi all,

Does anyone know why the head doesn't move in x or y when attempting to build a UBL cold mesh?

FWIW I'm doing this from the LCD menu.

This is on a Bigtreetech skr1.3 and the Marlin 2.0 bugfix branch but I've seen the same behaviour on a RAMPS and Marlin 1.x. I guess it must be something in my configuration given that I've seen it in both, but the 2.0 config was done from scratch and I can't see anything obvious.

Configuration.h