Hello everyone,
I'm pretty new to 3D printing and compiling the firmware. A few weeks ago I added a SKR1.1 board to my printer and for the most part, had a perfectly functional 3D printer until I added 3DTouch. I've noticed that I don't have EEPROM enabled so I cannot calibrate my auto bed leveling sensor correctly. None of the values stick because EEPROM is disabled.
Here's where it gets tricky if I enable/define EEPROM settings I cannot compile Marlin. It will fail every time. If I comment it out it works and I can compile. This is super frustrating (last 2 days have been a nightmare regarding setting up the auto leveling.).
I have uploaded an image of the error but I can upload more information and configs if needed.
Any Ideas?
I'm pretty new to 3D printing and compiling the firmware. A few weeks ago I added a SKR1.1 board to my printer and for the most part, had a perfectly functional 3D printer until I added 3DTouch. I've noticed that I don't have EEPROM enabled so I cannot calibrate my auto bed leveling sensor correctly. None of the values stick because EEPROM is disabled.
Here's where it gets tricky if I enable/define EEPROM settings I cannot compile Marlin. It will fail every time. If I comment it out it works and I can compile. This is super frustrating (last 2 days have been a nightmare regarding setting up the auto leveling.).
I have uploaded an image of the error but I can upload more information and configs if needed.
Any Ideas?